Pedada Solar Light Motion Sensor Luminaria Solar Lamp
100% Brand new!
Smart and energy saving solar PIR sensor control LED lights.
Automatic switching on when detecting people approaching and automatic dimming when detecting people(animal) left.
The lamp can illuminate the way for you and pedestrians at night, also a safeguard tool which can threaten bad guys by sudden burst.
It works in a 120degree angle and detects motion up to 6 meters away.
There are 2 knobs on the bracket, allow you to adjust the panel angle up to 360°.
With poly silicone solar panel, big enough(4.8x2.5") can convert solar energy into electricity, no need of outside power, energy efficiency and environmental protection, can work up to 8 hours if fully charged.
Built-in 17pcs high quality beads (16pcs 2835 white + 1pc 5050 red), brighter without increasing electricity bill.
Using high volume 18650 battery as the power bank, with a big capacity of 2200 mAh, can store more electricity under the solar system, safe and tough.
It is widely used for illumination in outdoor, courtyard, balcony, wall, street, manor, villa, garden, plaza, driveway, patio, entrance, etc.
Material: Safe ABS
Sensor sensitivity: Max 6m / 120 degrees
Solar panel power: 5.5V, 1.1W
Solar panel size: About 4.8x2.5"
Built-in 18650 battery: 3.7V, 2200mA
Beads: 16pcs 2835 LED (cool white) + 1pc 5050 LED(red)
Luminous: About 200lm
Colour temperature: Cool white, 6000 - 6500K
Delay time: 20 seconds
Night sensor: Less than 10 Lux
Charging time: 6~8 hours
Working time: 8~10 hours
Recommended install height: 2-2.2m/6.5-7.2ft
Angle adjusting: Almost 360°
Waterproof: YES, IP65
Lighting modes: Off / Dimming / Motion sensor
Shell size: About 19.5 x 11.5 x 5.7cm / 7.67 x 4.52 x 2.24"
Bracket size(WxL): About 2.5x16.3cm / 0.98x6.42"
How to use
1.Unlock and activate the device
The switch is below the panel, press it to activate before you mount.
2.Install the device
Please use the supplied screw sleeves and screws to mount the device on wall/board or somewhere else you want for lighting.
3.Charging via solar panel
Please install the unit face south and make sure the solar panel can get the good sunlight directly without any shelter or glass. Normally it can be fully charged in one day under ideal bright sunlight.
Motion sensor + dimming, charging at day, switch on at night, when people or something reaching the sensing area (within 6m), the light will be on, and shift to dim when people left the introduction area.
1.Keep the device away from fire.
2.Please fully charged the device before first use, for about 6~8 hours(via sunshine).
3.If there is no good sunlight in 3 months, the battery may be out of power, so you have to charge it by bright sunlight.
4.If there is no good sunlight or in winter sunlight, especial in north corners, it may take longer time to fully charge the device and this is very normal for solar products.
1 X Solar Powered Lamp
4 X Expansion Pillar-hinges
4 X Mount Screws
1 X User Manual